![]() Pool failover has been cleaned up without getwork They are irrelevant with local work generation and asic mining speeds and no getwork. Expiry and scan-time have also been REMOVED. Any attempt to tune this value is pointless and dates back to getwork. The option is now silently ignored to not break existing configurations but no more will any antminer binaries be able to set it to 8000 or something stupid. No pool should be providing getwork support in the modern mining era anyway. Only local work generation protocols are now supported (stratum, GBT and solo mining). Getwork support has been completely REMOVED. Fixes for various BFL devices not being properly recognised. Blockerupter tube driver has been disabled by default in binary builds since it's broken, and the configuration advises against it. Various drivers that failed to initialise (notably Antminer U3s) have been fixed by addressing various low level detection issues with other drivers. Long term stability updates, clean ups and driver updates. New release: Version 4.9.2 - 12th June 2015 Also the temp goes all the way up to 50 or so as if it was mining full speed. It's recognising it fine and running it as a monarch so if it's not working then they changed the protocol and, well, there's no sign of any updated protocol documentation and I do believe all communication channels between the cgminer development team and BFL have effectively been severed so. Here's the portion that was relevant last time. USB all: found 31 devices - listing known devices BitForceSC detect (5:1) Warning unknown firmware ' 1.4.50x00' using Ver2 USB init - BMA device 5:1 usbver=0200 prod='BitFORCE SHA256 SC' manuf='BUTTERFLY LABS' serial='FTYM9SV3' USB init, iManufacturer mismatch - BAS device 5:1 However, as with all of our drivers we write, you don't have to supply any device options to make them work in default settings.įor the U3, the options (if you wish to change the default working options) are -au3-freq, -au3-volt and -icarus-options With the official master cgminer 4.9.1 you most probably want to be using the icarus driver options if that is a bitmain U1/U2/U3 cgminer: -bmsc-options: unrecognized option If you ran it on the command line it will tell you that there's a problem with your options. It's some manufacturers version you were running before. There never has been and never will be -bmsc options in cgminer. Like: cgminer.exe -D -verbose -bmsc-options 115200:0.57 -o stratum+tcp://:3332 -u 2XdsyV7ThMVPp65PxSmWmjpoL1ctW1rJDk -p x -bmsc-voltage 0800 -bmsc-freq 1286īecause of i do this, i get nothing to see. cgminer -n will tell you what hardware it finds. ![]() More details if you add -D -verbose to the cgminer options.īut most likely it will show without them.Īlso. You at least need to open a command prompt and run the command and see what the error is.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |